Instruction Manual

Installation and Initial
Configuration
Before You Begin
WARNING: Do not
remove the device’s
cover. There are no user-
servicable parts inside.
Before you begin installation, you need the following:
• IP address for SA7100/SA7120 (only if you intend to use the
Remote Management).
• IP addresses and IP port numbers of servers.
• Keys/certificates. See Chapter 3 for information on obtaining
keys and certificates.
• Network cables, such as straight-through and/or crossover
cables. (The table in the section “Network Connections” in this
chapter identifies the types of cables you must use.)
• Phillips screwdriver (rack-mounting only).
• Rack-mounting screws (rack-mounting only).