Administrator's Guide

• deactivate If the drd activate command (which invokes setboot(1M)) has previously
been utilized and set the clone as the primary boot path, but the system has not yet been
rebooted, the drd deactivate command can be used to “undo” the drd activate
command. That is, the drd deactivate command will set the original system image to be
the primary boot path. The drd deactivate command always sets the primary boot path
to the active (currently booted) system image.
• mount Mounts all file systems in an inactive system image. The mount point of the root file
system is either /var/opt/drd/mnts/sysimage_000 or /var/opt/drd/mnts/
sysimage_001. If the inactive system image was created by the most recent drd clone
command, the mount point of the root file system is /var/opt/drd/mnts/sysimage_001.
If the inactive system image was the booted system when the most recent drd clone command
was run, the mount point of the root file system is /var/opt/drd/mnts/sysimage_000.
• rehost Copies the specified system information file—containing hostname, IP address, and
other system-specific information—to EFI/HPUX/SYSINFO.TXT on the disk to be rehosted.
• runcmd Runs a command on an inactive system image. Only a select group of commands
may be run by the runcmd mode. These are commands that have been verified to have no
effect on the booted system when executed by drd runcmd. Such commands are referred
to as DRD-safe. The commands kctune, swinstall, swjob, swlist, swmodify,
swremove, swverify, update-ux, and view are currently certified DRD-safe. An attempt
to execute any other command will result in a runcmd error. In addition, not every software
package may safely be processed by the sw* and update-ux commands. The DRD-safe
update-ux and SW-DIST commands are aware of running in a DRD session and will reject
any unsafe packages. For more information about DRD-safe packages, see drd-runcmd(1M).
NOTE: The drd runcmd command suppresses all reboots. The option -x autoreboot
is ignored when an swinstall, swremove, or update-ux command is executed by drd
runcmd.
• status Displays (system-specific) status information about the original disk and the clone
disk, including which disk is currently booted and which disk is activated (that is, the disk that
will be booted when the system is restarted).
• sync Propagates file system changes from the booted original system to the inactive clone
image.
• umount Unmounts all file systems in the inactive system image previously mounted by a drd
mount command.
• unrehost Removes the system information file, EFI/HPUX/SYSINFO.TXT, from a disk that
was rehosted, optionally preserving a copy in a file system on the booted system.
For details of DRD commands syntax, including all options and extended options, see DRD
commands.
1.4 Downloading and installing Dynamic Root Disk
For up-to-date detailed instructions about downloading and installing the DRD product, see https://
h20392.www2.hp.com/portal/swdepot/displayInstallInfo.do?productNumber=DynRootDisk.
NOTE: Due to system calls DRD depends on, DRD expects legacy Device Special Files (DSFs) to
be present and the legacy naming model to be enabled on HP-UX 11i v3 (11.31) servers. HP
recommends only partial migration to persistent DSFs be performed. For details of migration to
persistent DSFs, see theHP-UX 11i v3 Persistent DSF Migration Guide.
NOTE: On VxVM configurations, DRD expects OS Native Naming (osn) to be enabled. Enclosure
Based Naming (ebn) must be turned off.
8 About Dynamic Root Disk