Administrator's Guide

2 Adds NOTE messages.
3 (Default) Adds INFO messages (informational messages preceded by the * character.)
4 Adds verbose INFO messages.
5 Adds additional detailed INFO messages.
A.1.3 The drd deactivate command
The drd-deactivate(1M) command invokes the setboot(1M) command to set the primary boot disk
to the active (booted) system image the next time the system is booted.
NOTE: drd deactivate is a mechanism for “undoing” a drd activate command.
The drd deactivate command syntax is:
drd deactivate [-?] [-p] [-q] [-v] [-x extended option=value] [-x -?]
[-X option_file]
Options
-?
Displays the usage message for a DRD command. This option cannot be used with other options.
-p
Sets preview mode. When run with the -p option, a DRD command performs analysis without
running the command and reports any errors.
-q
Decreases the verbosity level by one each time it is specified. For example, -qq will reduce
the verbosity from the default value of 4 to 2. If both -x verbosity=5 and -qqq are included
on the command line, the effective verbosity is 2. The minimum verbosity level is 0. (See also
the -x verbosity option.)
-v
Increases the verbosity level by one each time it is specified. For example, -v will increase the
effective verbosity from the default value of 4 to 5. If both -x verbosity=1 and -vv are
included on the command line, the effective verbosity is 3. The maximum verbosity level is 5.
(See also the -x verbosity option.)
-x extended_option=value
Sets the extended option to a value.
-x -?
Displays the list of possible -x (extended) options.
-X option_file
Gets the extended options from a file.
Extended options
The following extended options are available:
-x alternate_bootdisk=block_device_special_file
This is the alternate boot disk. The alternate boot disk must be specified as a block device
special file.
-x HA_alternate_bootdisk=block_device_special_file
This is the High Availability alternate boot disk. The High Availability alternate boot disk must
be specified as a block device special file. High Availability alternate boot disk is supported
only on Itanium-based architecture and for PA-RISC systems that support hardware partitions.
-x ignore_unmounted_fs={true|false}
(Default is false) Controls whether a clone fails when an unmounted file system in the root
volume group is detected.
54 DRD commands