Specifications

d.
Top cover (see
Top cover on page 61)
e. System board (see
System board on page 73)
Remove the subwoofer:
1. Release the subwoofer cables (1) from the clips (2) and routing channel built into
the base enclosure.
2. Remove the two Phillips PM2.5×10.0 screws (1) that secure the subwoofer to the base enclosure.
3. Remove the subwoofer (2).
NOTE: The subwoofer includes four rubber isolators (3). These isolators are crucial to
the performance of the subwoofer.
Component replacement procedures
85