System information
Table Of Contents
- HP Pavilion dv6 Entertainment PC
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures
- Preliminary replacement requirements
- Component replacement procedures
- Service tag
- Computer feet
- Battery
- Webcam/microphone module
- Optical drive
- Memory module
- TV tuner module
- RTC battery
- Hard drive
- WLAN module
- Switch cover and keyboard
- Power button board
- Bluetooth module
- Display assembly
- Speaker
- Top cover
- Modem module
- Audio/infrared board
- USB board
- Power connector cable
- System board
- TV tuner module cable
- Modem module cable
- Fan/heat sink
- Processor
- Setup Utility
- Specifications
- Computer specifications
- 15.6-inch WXGA display specifications
- Hard drive specifications
- Blu-ray ROM DVD±R/RW SuperMulti DL Drive specification
- DVD±RW and CD-RW SuperMulti Double-Layer Combo Drive specifications
- System DMA specifications
- System interrupt specifications
- System I/O address specifications
- System memory map specifications
- Screw listing
- Backup and Recovery
- Connector pin assignments
- Power cord set requirements
- Recycling
- Index
4–38 Maintenance and Service Guide
Removal and replacement procedures
Remove the system board:
1. Disconnect the following cables from the system board:
1 Modem module cable
2 Audio/infrared board cable
✎
The audio/infrared board cable connects to a LIF connector on the system board.
3 USB board cable
✎
The USB board cable connects to a LIF connector on the system board.
4 Power connector cable
2. Remove the Phillips PM2.5×7.0 screw 1 that secures the system board to the base enclosure.
3. Lift up on the right side 2 of the system board until it rests at approximately a 45-degree angle.
4. Lift the system board to the right and up and out of the base enclosure 3.
Reverse this procedure to install the system board.