User guide

7
. Install the DIMM.
8
.
Install the access panel on page 20.
9
. Install the server into the rack (
Installing the server into the rack on page 35).
10. Connect each power cord to the server.
11
. Connect each power cord to the power source.
12
.
Power up the server on page 18.
Use RBSU ("HP ROM-Based Setup Utility" on page 102) to configure the memory mode.
For more information about LEDs and troubleshooting failed DIMMs, see "Systems Insight Display
LED combinations on page 5."
Hot-plug hard drive options
When adding hard drives to the server, observe the following general guidelines:
●
The system automatically sets all device numbers.
●
If only one hard drive is used, install it in the bay with the lowest device number.
●
Drives should be the same capacity to provide the greatest storage space efficiency when drives
are grouped together into the same drive array.
46 Chapter 5 Hardware options installation