Installation Guide

Post-install Security Tasks 39
#--------------------------------------------------
echo "BGP Configuration"
#--------------------------------------------------
exit all
configure
router
bgp
connect-retry 2
min-route-advertisement 1
outbound-route-filtering
extended-community
send-orf
exit
exit
group "internal"
type internal
neighbor <ip-address>
family vpn-ipv4
exit
neighbor <ip-address>
family evpn
exit
exit
no shutdown
exit
exit
exit all
Post-install Security Tasks
After installing the HP VSC software, there are a number of tasks that should be performed to
secure the system. Most of these tasks are obvious, but worth mentioning as a reminder.
• Change HP VSC “admin” password
By default, the HP VSC administrator username and password are “admin”. Finding the
default credentials for most systems and software is not difficult and is an easy security
exploit.
• Centralized HP VSC authentication and authorization
The HP VSC software is based on DCNOS and inherits many of the platform and security
features supported in DCNOS. Rather than rely on users defined locally on each VRS,
RADIUS and TACACS+ can be used to centralize the authentication and authorization for
VRS administrative users.