Manual

NOTE: Making changes to these settings causes the product to turn off and then on. Make changes
only when the product is idle.
1. At the product control panel, touch the Administration button, touch the Network Settings menu,
and then touch the Jetdirect Menu option.
2. Touch the down arrow until the Link Speed option displays.
3. Touch the Save button. The product turns off and then on.
Basic configuration using the Embedded Web Server
When the product is connected to the network, the Embedded Web Server (EWS) is automatically
available.
To start the EWS, open a web browser on a computer and type the IP address of the product. To find
the IP address or host name, touch the Network Address button on the Home screen on the product
control panel.
●
View or change network settings
●
Set or change the administrator password
●
Configure e-mail options
●
Save to Network Folder Setup
●
Configure save to SharePoint options
●
Configure USB storage device settings
●
Configure Quick Sets
●
Configure general security settings
●
Configure access control security settings
View or change network settings
You can use the Embedded Web Server to view or change IP configuration settings.
1. Open the Embedded Web Server.
2. Click the Networking tab to obtain network information. You can change settings as needed.
Set or change the administrator password
Use the Embedded Web Server to set an administrator password or change an existing password.
When set, you must enter this password before you can access and change configuration settings.
1. Open the Embedded Web Server and click the Networking tab.
2. In the left-side pane, click the Authorization option.
NOTE: If a password has previously been set, you are prompted to type the password. Type the
password, and then click the Apply button.
ENWW
Basic configuration using the Embedded Web Server
27