Manual

Table 3-6 Jetdirect menus (continued)

Menu item Sub-menu item Sub-menu item Values and Description

Refresh Yes

Link Speed The link speed and communication mode of the

Jetdirect server must match the network. The available

settings depend on the product and installed Jetdirect

server. Select one of the following link configuration

settings:

CAUTION: If you change the link setting, network

communications with the Jetdirect server and network

product might be lost.

Auto (default): The Jetdirect server uses auto-

negotiation to configure itself with the highest link

speed and communication mode allowed. If auto-

negotiation fails, either the 100TX Half value or the

10T Half value is set depending on the detected link

speed of the hub/switch port. (A 1000T half-duplex

selection is not supported.)

10T Half: 10 Mbps, half-duplex operation.

10T Full: 10 Mbps, full-duplex operation.

100TX Half: 100 Mbps, half-duplex operation.

100TX Full: 100 Mbps, full-duplex operation.

100TX Auto: Limits auto-negotiation to a maximum link

speed of 100 Mbps.

1000T Full: 1000 Mbps, full-duplex operation.

Configure language settings

To configure language settings, follow these steps:

1. At the product control panel, touch the Administration button, touch the Display Settings menu, and

then touch the Language Settings option.

2. Under Language, touch the language for the control panel display.

3. Under Keyboard Layout, touch the keyboard layout for the touch screen keyboard, and then touch

Save.

NOTE: The language you select can impact the organization of the keys on the touch screen

keyboard. Also note that there may be more than one keyboard layout for a specific language.

NOTE: You can also configure language settings by touching the Language button on the Home

screen.

ENWW

Basic configuration using the Administration menu