User guide

RGS properties 151
8-5 RGS Sender properties
RGS supports the following hierarchy of methods to set the Sender properties (see Figure 8-7).
Figure 8-7 Sender properties hierarchy
Properties set by methods higher on the list override properties set by methods lower on the list. For example, a
Sender command line property can override a property specified in the rgsenderconfig file. Similarly, an
rgsenderconfig file property can override a Sender default property.
The Sender does not support archive file properties because the Sender does not provide a user interface that
allows its properties to be modified.
Sender command line properties
See Section 8-3, “Setting property values on the command line.”
rgsenderconfig file properties
See Section 8-2, “Setting property values in a configuration file.”
Sender default properties
The Sender has a set of default properties that are built into the Sender. These are identical to the property values
in the Sender configuration file (rgsenderconfig) that is installed with the RGS Sender. However, as noted
previously, the properties in both the Receiver and Sender configuration files are initially commented out.
8-5-1 Sender property groups
RGS supports the following groups of Sender properties:
• General properties group
• Rgsender.IsRdpLogoutDetectionEnabled
• Rgsender.IsCopyRegionEnabled
• Rgsender.IsRegionLimitEnabled
• Rgsender.IsDisconnectOnLogoutEnabled
• Rgsender.MaxImageUpdateRate
• Rgsender.IsSnapToCodecEnabled
• Rgsender.IsBlankScreenAndBlockInputEnabled
• Rgsender.IsIloRemoteConsoleEnabled
• Rgsender.IsAnonymousConnectionForceEnabled
• Rgsender.IsCollaborationNotificationEnabled
• Microphone properties group
• Rgsender.Mic.IsEnabled
• Network timeout property group
• Rgsender.Network.Timeout.Error
• Rgsender.Network.Timeout.Dialog
Sender command line properties
rgsenderconfig file properties
Sender default properties
Highest
Lowest