User guide
RGS properties 137
Receiver command line properties
See Section 8-3, “Setting property values on the command line.”
rgreceiverconfig file properties
See Section 8-2, “Setting property values in a configuration file.”
Archive file properties
When the Receiver is run, the user can change a number of properties using menus on the Receiver Control Panel
and the Remote Display Window. When the Receiver exits, it saves the state of any properties that were changed
by the user—these are known as archive file properties.
Receiver default properties
The Receiver has a set of default properties that are built into the Receiver. These are identical to the property
values in the Receiver configuration file (rgreceiverconfig) that is installed with the RGS Receiver. However,
as noted previously, the properties in both the Receiver and Sender configuration files are initially commented out.
8-4-2 Receiver property groups
RGS supports the following groups of Receiver properties. Click on each group name to view the descriptions of
the properties in the group.
• Per-receiver properties
• General properties group
• Rgreceiver.IsBordersEnabled
• Rgreceiver.IsSnapEnabled
• Rgreceiver.IsAlwaysPromptCredentialsEnabled
• Rgreceiver.Directory
• Rgreceiver.MaxSenderListSize
• Rgreceiver.IsMatchReceiverResolutionEnabled
• Rgreceiver.IsMatchReceiverPhysicalDisplaysEnabled
• Rgreceiver.RecentWindowPositions (deprecated)
• Rgreceiver.ConnectionWarningColor
• Rgreceiver.IsGlobalImageUpdateMutable (deprecated)
• Rgreceiver.IsGlobalImageUpdateEnabled
• Rgreceiver.MaxImageUpdateRequests
• Browser properties group
• Rgreceiver.Browser.IsMutable
• Rgreceiver.Browser.Name
• Audio properties group
• Rgreceiver.Audio.IsMutable
• Rgreceiver.Audio.IsEnabled
• Rgreceiver.Audio.Quality
• Rgreceiver.Audio.IsFollowsFocusEnabled
• Rgreceiver.Audio.IsInStereo
• Microphone property group
• Rgreceiver.Mic.IsEnabled
• USB properties group
• Rgreceiver.Usb.IsMutable
• Rgreceiver.Usb.ActiveSession
• Rgreceiver.Usb.IsEnabled