User guide

Advanced capabilities 106
Figure 6-14 shows the presence of the USB drive key on the Local Computer before the remote USB attachment is
made.
Figure 6-14 Prior to remote attachment of the USB drive key
To connect the USB drive key to a Remote Computer in Directory Mode, perform the following steps:
1. Click the USB tab on the Receiver Control Panel.
2. Click the Enable Remote USB checkbox to enable the remote USB connection.
3. Select the IP address (or hostname) of the Remote Computer, and click Connect.
4. Once connection has been established, remove and re-insert the USB drive key—this step is required to
initiate the remote USB attachment.
As shown in Figure 6-15, the USB drive key is now attached to the Remote Computer, and is no longer available
to the Local Computer.
Figure 6-15 After remote attachment of the USB drive key
Remote Computer Local Computer
Remote Computer Local Computer