Installation Manual

(Optional) Sensor Base Stations 58

Press and hold the UP and DOWN arrows simultaneously for a minimum of 2 seconds to exit.

Programming the voltage mode

Set the Volts Mode type according to the specific power connection type.

Power connection type ION setting

4wire wye (4 wire, 3 phases + neutral)

Direct Delta (3 wire, 3 phases, no neutral)

dELd

Programming the CT model

NOTE: All of the CTs must have the same ratings.

Set the primary and secondary transducer values:

• Primary transducer type—Ct1

• Secondary transducer type—Ct2

An example of a 200A CT is: