Getting Started Guide

1-7
Hardware Overview and Quick Start Installation and Initial Setup
Hardware
Ethernet Ports
The DCM Controller has two 10/100/1000 Base-T RJ-45 ports labeled:
■ 1 (left port)
■ 2 (right port)
Only port 1 is active at this time. This port supports the following standards:
■ IEEE 802.3ab 1000Base-T
■ IEEE 802.3u 100Base-TX
■ IEEE 802.3 10Base-T
Safety
DCM Controller complies with the following:
■ EN60950-1 / IEC 60950-1
■ CSA 22.2 No. 60950-1
■ UL 60950-1
LEDs
The DCM Controller has three LEDs on its left front panel and two LEDs on
Ethernet port 1.
Figure 1-3. LEDs on the Front Panel
■ Power LED—glows green when the DCM Controller is powered on.
■ Fault LED—blinks orange to indicate a problem with the DCM Controller
■ Locator LED—glows blue when you turn the LED on through the menu
interface, identifying which device you are configuring