Getting Started Guide

2-16
Detailed Hardware Installation and Initial Setup Steps
Overview
Figure 2-17. Ping Test Output Showing a Successful Test
d. To ping a different IP address, press Enter to return to the Diagnostics
menu, and then repeat the steps to send a ping.
e. When you are finished, press Enter and 0 to return to the Main Menu.
f. Exit the console interface.
8. Run the Initialization Script
After you configure the DCM Controller’s IP settings, you must run an initializa-
tion script to configure the DCM Controller with settings for your environment.
(You can also configure these settings manually if you prefer. See “Manual
Initialization” on page B-1 in Appendix 2: “Detailed Hardware Installation and
Initial Setup Steps.”)
1. Use terminal software such as Tera Term or PuTTY to establish one of the
following sessions with the DCM Controller.
• A Secure Shell (SSH) session to the DCM Controller’s IP address
• A console session (connecting your management station to the DCM
Controller’s console port)