Getting Started Guide

2-15
Detailed Hardware Installation and Initial Setup Steps
Overview
9. Press y to confirm that you want to make these changes and then press
Enter.
10. Press 0 to return to the Main Menu.
11. Press 0 to log out of the console interface.
12. After you set the IP address, you should verify connectivity by pinging:
• The DCM Controller’s default gateway
• Your management station
a. Access the console menu and press 2 for Diagnostics.
b. Press 1. Ping Test.
Figure 2-16. The Ping Test Screen of the Console Interface
c. At the prompt, enter the IP address to which you want to confirm
connectivity.
By default, the IP address is set to the DCM Controller’s default
gateway. Press Enter to ping the default gateway.