Getting Started Guide

2-14
Detailed Hardware Installation and Initial Setup Steps
Overview
Figure 2-15. Configuring IP Address in the Console Interface
5. At the IP address prompt, enter an IP address in standard IP notation and
press Enter.
IP address (default 192.168.0.2):
Optionally, you can accept the default IP address in parentheses by
pressing Enter without typing an IP address.
6. At the Subnet mask prompt, enter the subnet mask in standard IP notation
and press Enter.
Subnet mask (default 255.255.255.0):
Optionally, you can accept the default subnet mask in parentheses by
pressing Enter without typing a subnet mask.
7. At the Default gateway prompt, enter the IP address of the DCM Control-
ler’s gateway and press Enter.
Default gateway (default 192.168.0.1):
Optionally, you can accept the default gateway in parentheses by pressing
Enter without typing a gateway address.
8. At the DNS address prompt, enter the IP address of the DCM Controller’s
DNS server and press Enter.
DNS address (default 0.0.0.0):
Optionally, you can accept the DNS address in parentheses by pressing
Enter without typing a DNS address.