Getting Started Guide

2-9
Detailed Hardware Installation and Initial Setup Steps
Overview
Figure 2-5. Panel LCD Menu > Configuration
2. Select IP Address—Port 1.
Figure 2-6. Panel LCD Menu > Configuration >
IP Address—Port 1
3. Set the DCM Controller’s IP address.
a. Use the left and right arrow buttons to move the cursor from digit to
digit. Then use the up and down arrow buttons to alter the selected
digit.
Note that the DCM Controller treats each set of three digits as a single
number. For example, suppose the first three digits currently display
009. If the cursor is at the third digit and you press the up arrow button,
the digits display 010.
Figure 2-7. Panel LCD Menu > Configuration >
IP Address—Port 1 (IP Address)