Getting Started Guide

1-16
Hardware Overview and Quick Start Installation and Initial Setup
Quick Start Hardware Installation and Initial Setup
Figure 1-11. Panel LCD Menu > Ping Test
iv. Enter the IP address that you want to ping.
By default, the IP address is set to the DCM Controller’s default
gateway. Press the accept button to ping the default gateway.
To ping a different IP address, use the left and right arrow buttons
to move the cursor from digit to digit. Use the up and down arrow
buttons to alter the selected digit. Then, press the accept button.
The results of the ping are displayed.
Figure 1-12. Panel LCD Menu > Ping Test > Results
j. Press the left arrow button to return to the main menu.
8. Run the initialization script.
After you configure the DCM Controller’s IP settings, you must run an
initialization script to configure settings for your network. (If you
would prefer to manually configure the settings for your network
environment—rather than run the initialization script—see Appendix
B: “Manually Editing DCM Controller Files.”)
a. Use terminal software such as Tera Term or PuTTY to establish one
of the following sessions with the DCM Controller.
– An SSH session to the DCM Controller’s IP address
– A console session (connecting your management station to the
DCM Controller’s console port)