Getting Started Guide

1-15
Hardware Overview and Quick Start Installation and Initial Setup
Quick Start Hardware Installation and Initial Setup
Figure 1-9. Panel LCD Menu > Configuration > IP Address—Port 1 (Gateway)
h. Set the IP address of the DCM Controller’s default gateway.
By default, the DCM Controller sets the default gateway to the lowest
IP address in its subnet. If necessary, use the arrow buttons to change
the address. Then, press the accept button.
The DCM Controller operating system checks the new IP settings.
If the IP settings are valid, the panel LCD displays:
IP Address OK
Setting new IP...
Note IP settings can be valid but incorrect for your environment. Always check
connectivity with the ping test.
i. Verify connectivity by pinging the DCM Controller’s default gateway
and your management station.
i. Access the main LCD menu.
ii. Press the accept button to access the main menu initially; press
the cancel button to move back a screen.
Figure 1-10. Panel LCD Main Menu
iii. Select Ping Test.