Getting Started Guide

1-14
Hardware Overview and Quick Start Installation and Initial Setup
Quick Start Hardware Installation and Initial Setup
Figure 1-5. Panel LCD Menu > Configuration
c. Select IP Address—Port 1.
Figure 1-6. Panel LCD Menu > Configuration > IP Address—Port 1
d. Set the DCM Controller’s IP address.
Use the left and right arrow buttons to move the cursor from digit to
digit. Use the up and down arrow buttons to alter the selected digit.
Figure 1-7. Panel LCD Menu > Configuration > IP Address—Port 1 (IP Address)
e. After you enter the correct IP address, press the accept button.
Figure 1-8. Panel LCD Menu > Configuration > IP Address—Port 1 (Subnet Mask)
f. Use the arrow buttons to change the subnet mask.
g. After you enter the correct subnet mask, press the accept button.