HP LaserJet Pro MFP M125-126 M127-128-Warranty and Legal Guide

电信(传真)产品附加声明
欧盟电信运营声明
本产品设计用于连接到欧洲经济区 (EEA) 国家/地区的模拟公共交换电话网 (PSTN)
它符合 EU R&TTE Directive 1999/5/EC (Annex II) 的要求,并带有 CE 合格标志。
有关详细信息,请参阅本手册其它部分中制造商发布的一致性声明。
然而,由于各个国家/地区的 PSTN 间存在着差异,本产品不能无条件保证在每个 PSTN 终接点上都可以
成功运行。产品的网络兼容性取决于客户准备 PSTN 连接时所选的适当设置。请按照用户手册中提供的
说明进行操作。
如果遇到网络兼容性问题,请联系您操作所在国家/地区的设备供应商或 HP 服务台。
PSTN 端点的连接可能需要满足当地 PSTN 运营商的其它要求。
New Zealand Telecom Statements
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the
item complies with minimum conditions for connection to its network. It indicates no endorsement of the
product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item
will work correctly in all respects with another item of Telepermitted equipment of a dierent make or model,
nor does it imply that any product is compatible with all of Telecom
s network services.
This equipment may not provide for the eective hand-over of a call to another device connected to the same
line.
This equipment shall not be set up to make automatic calls to the Telecom 111Emergency Service.
This product has not been tested to ensure compatibility with the FaxAbility distinctive ring service for New
Zealand.
Additional FCC statement for telecom products (US)
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the back
of this equipment is a label that contains, among other information, a product identier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
The REN is used to determine the quantity of devices, which may be connected to the telephone line. Excessive
RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not
all, areas, the sum of the RENs should not exceed ve (5.0). To be certain of the number of devices that may be
connected to the line, as determined by the total RENs, contact the telephone company to determine the
maximum REN for the calling area.
This equipment uses the following USOC jacks: RJ11C.
An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is designed
to be connected to the telephone network or premises wiring using a compatible modular jack, which is Part 68
compliant. This equipment cannot be used on telephone company-provided coin service. Connection to Party
Line Service is subject to state taris.
If this equipment causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. If advance notice is not practical, the telephone company
ZHCN
电信(传真)产品附加声明
47