User Manual

Unload a roll
If there is paper on the roll, you can unload it from the front panel: tap , then Unload roll. Afterwards, the
multi-sheet tray will become the default active paper source.
If the end of the paper is no longer attached to the core, the front panel asks you to unload the roll manually.
After unloading, the multi-sheet tray is the default active paper source.
Load a single sheet
NOTE: Roll paper and single sheets use the same input slot in the printer.
NOTE: Sheets of width 329 mm (12.95 in) or less should be loaded from the multi-sheet tray.
1. At the front panel, tap , then Load single sheet.
2. If a roll is already loaded, you have to wait while it is automatically unloaded.
3. Select your paper category and type. If you do not see your paper type in the front panel, tap More paper
types. If you still cannot nd your paper type in the whole list, see Paper type is not in the driver
on page 86.
4. If your printer is a T520, open the roll cover.
5. When prompted by the front panel, insert the sheet into the right-hand side of the input slot.
WARNING! Do not push your ngers inside the printer's paper path.
ENWW Unload a roll 33