User's Manual

Connecting to External Devices
Connecting to the Computer
1. Be sure the monitor, computer and all attached devices are turned off.
2. Connect the signal input cable:
a. For analog operation, connect the VGA (D-sub) signal cable to the RGB IN (1) connector
on the rear of the monitor and the other end to the VGA connector (2) on the computer.
NOTE: If connecting to a Mac computer, use the standard Macintosh adapter (3).
Figure 3-16 Connecting the VGA Signal Cable
b. For digital operation, connect the HDMI to DVI signal cable (not included) to the HDMI/DVI
(1) connector on the rear of the monitor and the other end to the DVI connector (2) on the
computer.
NOTE: Use shielded signal interface cables with ferrite cores to maintain standard
compliance for this product.
Figure 3-17 Connecting the HDMI to DVI Signal Cable
3. Connect the audio cable (sold separately) to the Audio (RGB/DVI) (1) connector on the rear of
the monitor and the other end to the line out jack (2) on the computer.
Figure 3-18 Connecting the Audio
NOTE: The ferrite core can be used to reduce electromagnetic waves when connecting an
audio cable. As shown in the image, fit the ferrite core to the audio cable. The ferrite core needs
to be separated from the mold by 5 centimeters.
ENWW Connecting to External Devices 13