Reference Guide

Value ValueMap Description
5
Path Error
path has an error
condition
7.13 HPSA_EncProtocolEndpoint
The HPSA_EncProtocolEndpoint class has been extended from CIM_SCSIProtocolEndpoint and
represents the protocolendpoint of an enclosure port. The following properties have been added to
represent the protocol (command set) associated to a target port.
7.13.1 HPSA_ EncProtocolEndpoint.ProtocolIFType
ProtocolIFType is an enumeration that is synchronized with the IANA ifType MIB. Note that if the
ProtocolIFType is set to 1 (Other), then the type information should be provided in the
OtherTypeDescription string property.
7.13.2 HPSA_ EncProtocolEndpoint.OtherTypeDescription
The type of protocol endpoint when the Type property of this class (or any of its subclasses) is set to 1
(Other).Value is set to the string ‘SCSI’.
7.13.3 HPSA_ EncProtocolEndpoint.Role
Value is set to 3 for Target port.
7.13.4 HPSA_ EncProtocolEndpoint.Path
Value indicates whether the enclosure port path is active or not.
Table 23 - HP Smart Array profile: HPSA_ EncProtocolEndpoint.Path
Value
ValueMap
0
Unknown
2
Active
3
Passive
5
Path Error
7.14 HPSA_EncSASPort
The HPSA_EncSASPort class has been extended from CIM_LogicalPort to define an enclosure target
port.
7.14.1 HPSA_EncSASPort. OperationalStatus
This value indicates the Operational Status of the port. Value is set to 2 (OK) .
7.14.2 HPSA_EncSASPort.PortType
PortType defines the type of port. Value is set to 94 for SAS port.
7.14.3 HPSA_EncSASPort.UsageRestriction
A LogicalPort might be identifiable as a front end or back end port. If there is no restriction on the use of
the port, then the value should be set to 'not restricted'. Value is set to 4 (Not restricted) for Target port.
Version 2.13.1 63