Reference Guide

7.10.3 HPSA_ISASSCSIProtocolEndpoint.Role
Value is set to 2 for Initiator port.
7.11 HPSA_ ISASPort
The HPSA_ISASPort class has been extended from CIM_ LogicalPort as defined in SNIA SAS Initiator
ports profile. The following properties have been added to represent an initiator port.
7.11.1 HPSA_ISASPort.OperationalStatus
This value indicates the Operational Status of the port. Value is set to 2 (OK) .
7.11.2 HPSA_ISASPort.PortType
PortType defines the type of port. Value is set to 94 for SAS port.
7.11.3 HPSA_ISASPort.UsageRestriction
A LogicalPort might be identifiable as a front end or back end port. If there is no restriction on the use of
the port, then the value should be set to 'not restricted'. Value is set to 4 (Not restricted) for initiator port.
7.12 HPSA_ SCSIInitiatorTargetLogicalUnitPath
The HPSA_SCSIInitiatorTargetLogicalUnitPath class has been extended from
CIM_SCSIInitiatorTargetLogicalUnitPath to represent a path between a SCSI initiator, target, and logical
unit..
7.12.1 HPSA_ SCSIInitiatorTargetLogicalUnitPath.Initiator
This value is a reference to an instance of HPSA_ISASSCSIProtocolEndpoint.
7.12.2 HPSA_ SCSIInitiatorTargetLogicalUnitPath.Target
This value is a reference to an instance of HPSA_TSASSCSIProtocolEndpoint.
7.12.3 HPSA_ SCSIInitiatorTargetLogicalUnitPath.LogicalUnit
This value is a reference to an instance of HPSA_StorageExtent.
7.12.4 HPSA_ SCSIInitiatorTargetLogicalUnitPath.State
The state of this path. Values are defined as follows.
Table 31 - HP Smart Array profile: HPSA_SCSIInitiatorTargetLogicalUnitPath.State
Value ValueMap Description
0
Unknown
The path status cannot be
ascertained
2
Active
The path is active and
healthy
3
Passive
Path is healthy but is not
active or is the standby
path
62 Version 2.13.1