Reference Guide

7.8.2 HPSA_TSASSCSIProtocolEndpoint.OtherTypeDescription
The type of protocol endpoint when the Type property of this class (or any of its subclasses) is set to 1
(Other).Value is set to the string ‘SCSI’.
7.8.3 HPSA_TSASSCSIProtocolEndpoint.Role
Value is set to 3 for Target port.
7.8.4 HPSA_TSASSCSIProtocolEndpoint.Path
Value indicates whether the diskdrive port path is active or not.
Table 22- HP Smart Array profile: HPSA_TSASSCSIProtocolEndpoint.Path
Value ValueMap
0
Unknown
2
Active
3
Passive
5
Path Error
7.9 HPSA_TSASPort
The HPSA_TSASPort class has been extended from CIM_LogicalPort as defined in SNIA SAS Target
ports profile. The following properties have been added to represent a target port.
7.9.1 HPSA_TSASPort. OperationalStatus
This value indicates the Operational Status of the port. Value is set to 2 (OK) .
7.9.2 HPSA_TSASPort.PortType
PortType defines the type of port. Value is set to 94 for SAS port.
7.9.3 HPSA_TSASPort.UsageRestriction
A LogicalPort might be identifiable as a front end or back end port. If there is no restriction on the use of
the port, then the value should be set to 'not restricted'. Value is set to 4 (Not restricted) for Target port.
7.10 HPSA_ISASSCSIProtocolEndpoint
The HPSA_ISASSCSIProtocolEndpoint class has been extended from CIM_SCSIProtocolEndpoint as
defined in SNIA SAS Initiator ports profile. The following properties have been added to represent the
protocol (command set) associated to an initiator port.
7.10.1 HPSA_ISASSCSIProtocolEndpoint.ProtocolIFType
ProtocolIFType is an enumeration that is synchronized with the IANA ifType MIB. Note that if the
ProtocolIFType is set to 1 (Other), then the type information should be provided in the
OtherTypeDescription string property.
7.10.2 HPSA_ISASSCSIProtocolEndpoint.OtherTypeDescription
The type of protocol endpoint when the Type property of this class (or any of its subclasses) is set to 1
(Other).Value is set to the string ‘SCSI’.
Version 2.13.1 61