Reference Guide

7.4.14 HPSA_StorageVolume. RapidParityPercentComplete
This property reports Rapid Parity percentage .This is a conditional property reported only when the
logical volume supports Rapid Parity and the Rapid Parity is in progress. This property will not be
populated when Rapid Parity is in pending state,
7.4.15 HPSA_StorageVolume. SSDSmartPathStatus
This property reports Solid State drive smart path status.This is a conditional property reported only when
the logical volume supports smart path status.
Value ValueMap Description
0
Unknown
Cannot determine the logical drive's SSD
Smart Path status.
1
Other
2
SSD SmartPath Enabled
SSD Smart path for this logical drive is
enabled. The Smart Array controller driver is
able to use an SSD Smart Path for this
logical drive.
3
SSD SmartPath Disabled
SSD Smart Path for this logical drive is
disabled. Check Smart Array controller
documentation.
Update Driver
Updated Smart Array controller driver is
needed in order for the SSD Smart Path to
be supported for this logical drive.
7.5 HPSA_CacheVolumeStorageVolume
Whenever a LUN on LUN Caching is supported there will be instances this association class. The
LUN can be of data or cache type. And there is a One-to-One association between a data LUN and
Cache LUN. To show this one-to-one association this class is created.
Here Antecedent will be the StorageVolume i.e. Primary LUN and Dependent will be
CacheVolume i.e. Cache LUN.
Properties
Requirements
Keys
Antecedent
Mandatory
Key :Reference
HPSA_StorageVolume
Dependent
Mandatory
Key: Reference
HPSA_StorageVolume
7.6 HPSA_StoragePool
The HPSA_StoragePool class has been extended from CIM_StoragePool class as defined in SNIA Block
Services profile.
7.6.1 HPSA_StoragePool.Identify(uint32 Duration)
This method will cause hard drives that make up this Storage Pool to set some indicator (e.g. set or blink
drive LEDs) for the given duration (default duration is 30 seconds). After the duration has expired the
drive indicator(s) will return to normal use
58 Version 2.13.1