Reference Guide
Value ValueMap Description
4
configured non-redundant
Volume is configured with
redundant paths but is
currently not redundant
possibly due to failure of 1
or more paths or a
configuration error
7.4.8 HPSA_StorageVolume.OSName
This should display the volume name as it is known to the operating system if known otherwise it shall
either show “Unknown” or not be assigned a value.
7.4.9 HPSA_StorageVolume.Identify(uint32 Duration)
This method will cause hard drives that make up this logical volume to set some indicator (e.g. set or blink
drive LEDs) for the given duration (default duration is 30 seconds). After the duration has expired the
drive indicator(s) will return to normal use
Return values for Identify() method shall be the same as specified in Table 14 where the method
execution behavior matches the return code description.
Identify() parameters shall be the same as those specified in Table 15.
7.4.10 HPSA_StorageVolume. LogicalVolumeType
This property returns the type of logical volume . And default value of this property is “Other”.
Table 26 - HP Smart Array profile: HPSA_StorageVolume.LogicalVolumeType
Value ValueMap Description
0
Unknown
Unable to determine the type
1
Other
When LUN on LUN caching is
not supported
2
Cache LUN
Logical drive is a cache
volume
3
Data LUN
Logical drive is being utilized
by cache volume.
7.4.11 HPSA_StorageVolume. RelatedLUN
If the Storage Volume supports LUN on LUNCaching then this property shall be available. If the volume
is a caching LUN, the value of the primary LUN will be available in this property and if the volume is
Primary LUN then value of cache LUN will be reported in this property.
7.4.12 HPSA_StorageVolume.CacheVolumeCacheState
If the Storage Volume supports LUN on LUN caching then this property shall be available. This property
will report the cache state for the cache volume.
56 Version 2.13.1