Reference Guide

7.3.21 HPSA_DiskDrive. IsSanitizeEraseSupported
Boolean value indicates whether the disk supports sanitize erase.
7.3.22 HPSA_DiskDrive. IsCryptoScrambleEraseSupported
Boolean value indicates whether disk supports crypto scramble erase.Available only when
IsSanitizeEraseSupported is true.
7.3.23 HPSA_DiskDrive. IsBlockEraseSupported
Boolean value indicates whether disk supports block erase. Available only when
IsSanitizeEraseSupported is true.
7.3.24 HPSA_DiskDrive. IsOverWriteEraseSupported
Boolean value indicates whether controller supports overwrite erase. Available only when
IsSanitizeEraseSupported is true.
7.4 HPSA_StorageVolume
The HPSA_StorageVolume class has been extended from CIM_StorageVolume class as defined in SNIA
Block Services profile.
7.4.1 HPSA_StorageVolume.Deleteable
Boolean value indicates whether this logical volume can be deleted. In most configurations, only the
volume that is physically located at the end of the raid set can be deleted.
7.4.2 HPSA_StorageVolume.Accelerator
Value that indicates the status of the accelerator for this logical volume.
Supported values are as follows
Table 25 - HP Smart Array profile: HPSA_StorageVolume.Accelerator
Value
ValueMap
0
Unknown
1
Enabled
2
Disabled
7.4.3 HPSA_StorageVolume.StripeSize
Value indicates the current stripe size in Bytes for the Logical Volume. Note that this may not have a
value for some configurations (e.g. RAID 0 with a single drive, RAID 1 with only two drives).
7.4.4 HPSA_StorageVolume.PercentComplete
During a rebuild or expand operation, this will indicate progress as a percentage value. Note this value
shall only be populated when a rebuild or expand operation is being performed on this logical volume.
52 Version 2.13.1