Reference Guide

7.3.7 HPSA_DiskDrive.DriveConfiguration
Indicates the how the drive has been configured by the controller. Supported values are:
Table 20 - HP Smart Array profile: HPSA_DiskDrive.DriveConfiguration
Value
ValueMap
0
Unknown
1
Unconfigured
2
Data
3
Spare
4
Non RAID
7.3.8 HPSA_ DiskDrive.DriveRotationalSpeed
Value indicates the rotational speed of the drive in revolutions per minute.
7.3.9 HPSA_DiskDrive.DriveHasMNPData
Boolean value indicates that the drive supports reporting of Monitoring and Performance data counters.
7.3.10 HPSA_DiskDrive.DrivePlacement
Value indicates where the drive is located with respect to the controller.
Table 21 - HP Smart Array profile: HPSA_DiskDrive.DrivePlacement
Value ValueMap
0
Unknown
1
Internal
2
External
7.3.11 HPSA_DiskDrive.ControllerLocation
This value indicates the location of the controller with which the disk drive is attached to.
7.3.12 HPSA_DiskDrive.OperationalStatus.
This value indicates the Operational Status of the disk drive. Operationalstatus[0] depicts the Primary
operational status of the disk drive .
OperationalStatus[1] values shows the secondary(or extended) operational status of the disk drive.
The below values shows the possible OperationalStatus[1] values to account for the failure of a path from
controller to disk.
• If any path to the disk making up this volume is currently set to 5 (Path Error) and there still exists
at least one path that is active and the disk is currently ok then
:
o OperationalStatus [0]: 3 (degraded)
o OperationalStatus[1]: 32771 (0x8003) (
Physical Path In Error)
• If all paths on all disks are set to 5 (Path Error) then:
o OperationalStatus[0]: 6 (error)
o OperationalStatus[1]: 32771(0x8003) (
Physical Path In Error)
The below values shows the possible OperationalStatus[1] values related to secure erase operations.
Table 22 - HP Smart Array profile: HPSA_DiskDrive.OperationalStatus
Version 2.13.1 49