Reference Guide

16 Version 2.3.0
8 Methods
8.1 Method: HP_ManagementProcessor.RequestStateChange() Optional
Implementations may support the RequestStateChange method to change the state of the management
processor. If implemented, the provider should support the “RequestedState” property with a value of 11
(Reset). Support of the “Job” and “TimeoutPeriiod” parameters are optional.
8.2 Profile Conventions for Operations
Support for operations for each profile class (including associations) is specified in the following sub-
clauses. Each sub-clause includes either a statement “All operations are supported as described by
DSP200 v1.2” or a table listing all the operations that are Unspecified by this profile or where the profile
requires behavior other that described by DSP200.
The default list of operations is as follows:
 GetInstance
 Associators
 AssociatorNames
 References
 ReferenceNames
 EnumerateInstances
 EnumerateInstanceNames
A compliant implementation shall support all the operations in the default list for each class, unless the
Requirements column states something other than Mandatory.
8.3 HP_ManagementProcessor
Table 3 lists operations that either have special requirements beyond those from DSP0200 or shall not be
supported. All other operations may be supported as defined in DSP0200.
Table 3 – Operations: HP_ManagementProcessor
Operation
Requirement
Messages
GetInstance
Mandatory
None
Associators
Unspecified
None
AssociatorNames
Unspecified
None
References
Unspecified
None
ReferenceNames
Unspecified
None
EnumerateInstances
Unspecified
None
EnumerateInstanceNames
Unspecified
None