Reference Guide

16 Version 3.0.0
The HP_ComputerSystem.SendTestIndication() method shall return 3 (Busy) if the method is in the
process of sending a test indication from a previous request. Caller should retry the request. The method
shall delay generation of test indications requested to reduce the possibility of flooding.
The HP_ComputerSystem.SendTestIndication() method shall return 2 (Failed) if the request to send the
indication could not be processed due to an internal error. Caller should not retry the request.
The HP_ComputerSystem.SendTestIndication() method shall return 0 (OK) if the request to send the
indication was accepted. Table 3 defines the indications that shall be sent.
Table 5 – Test Indications
Property Name
Property Implementation
CIM_Indication
PerceivedSeverity
2 (Informational)
3 (Warning)
6 (Critical)
CIM_AlertIndication
Description
“This is an Informational Test Event.”
“This is a Warning Test Event.”
“This is a Critical Test Event.”
AlertType
5 (Device Alert)
EventID
“1”
“2”
“3”
ProviderName
“HP Test”
RecommendedActions
“No action is recommended.”
HP_AlertIndication
Summary
“Test Event”
ProbableCause
1 (Other)
ProbableCauseDescription
“Test Indication”
8.2 Profile Conventions for Operations
Support for operations for each profile class (including associations) is specified in the following sub-
clauses. Each sub-clause includes either a statement “All operations are supported as described by
DSP200 v1.2” or a table listing all the operations that are Unspecified by this profile or where the profile
requires behavior other that described by DSP200.
The default list of operations is as follows:
 GetInstance
 Associators
 AssociatorNames
 References