Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide (July 2000)

3-18
Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide
Compaq Confidential – Need to Know Required
Writer:
Bob Young
Project:
Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide
Comments:
Part Number:
127510-002
File Name:
d-ch3 Installation.doc
Last Saved On:
7/12/00 11:24 AM
2. Identify and orient the parts of the rail slides and hardware needed for
your rack. Figure 3-10 shows the parts required for standard
rackmounting.
NOTES:
All hardware required for rackmounting the Expansion Unit and Base Module into
a Compaq rack is supplied. You will need a #2 Phillips screwdriver.
The left and right rail slides are alike, so there is no risk of confusing the parts on
reassembly.
The front of the cabinet, and front rails in this text refers to where the module face will be
exposed (typically opposite from the main power source location). The main power source
location thus becomes the rear of the cabinet, and where the rear rails exit.
3. Locate the screw holes in the front and rear rails of the cabinet or
equipment rack where the module is to be installed.
CAUTION:
The cooling fan at the rear of the module must not be obstructed
when the module is installed in the rack. It is advisable to allow 2 in (5 cm) of
clearance behind the rear panel of the module.
4. Refer to the Compaq rackmounting template, which is included with
each module. Note that the inner slide has two sets of holes. When
installing the inner slides, make sure you use the upper set of holes.