Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide (July 2000)

Installation

3-13

Compaq Confidential – Need to Know Required

Writer:

Bob Young

Project:

Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide

Comments:

Part Number:

127510-002

File Name:

d-ch3 Installation.doc

Last Saved On:

7/12/00 11:24 AM

SHR-1708

Figure 3-8. Belt block with belt in place

Table 3-5

Belt Block with Belt in Place

Figure Legend Description

Belt

Gap visible

Block

10.

Tighten the four screws that hold the belt retaining plates.

11.

Pull out the paper clip previously installed in the base section. This

applies the proper tension to the belt.

12.

Locate the two captive screws in the car. Screw them backward one turn

to line them up and then screw them approximately one thread into the

bracket in the car so they are held in an upright position.

13.

Position the belt block at least six inches from the motor drive pulley.

14.

Locate the spring-loaded wheels of the car. Engage the spring-loaded

wheels in the track, while positioning the car so the captive screws are

directly over the holes in the belt block (Figure 3-9 and Table 3-6).

IMPORTANT:

Figure 3-9 omits the door on the car for clarity. Do not remove the door.