Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide (July 2000)

3-12

Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide

Compaq Confidential – Need to Know Required

Writer:

Bob Young

Project:

Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide

Comments:

Part Number:

127510-002

File Name:

d-ch3 Installation.doc

Last Saved On:

7/12/00 11:24 AM

Thread the belt from the motor drive counter-clockwise around the idler

pulley and back to the right end (Figure 3-5).

Holding the ends of the belt as shown in Figure 3-7, the two ends should

be touching or very slightly overlapping.

SHR-1707

Figure 3-7. Checking belt length

Loosen the four screws that hold the belt retaining plates to the block.

Slide the ends of the belt under the plate until they engage the teeth on

the block. Both ends of the belt should be visible through the gap

between the plates as shown in Figure 3-8 (see Table 3-5). Set the belt

so there is only a small space between the ends of the belt

(approximately 1/32 of an inch).