Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide (July 2000)

Installation

3-7

Compaq Confidential – Need to Know Required

Writer:

Bob Young

Project:

Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide

Comments:

Part Number:

127510-002

File Name:

d-ch3 Installation.doc

Last Saved On:

7/12/00 11:24 AM

Orientation of Parts During Assembly

To determine the orientation of an extension section, examine the flanges on

the edges of the section, and note that they are dissimilar. Position the section

so that its orientation matches that of the elevator base.

Figure 3-4 shows a typical PTM assembly (see Table 3-3). The motor drive

section always goes on top, and the base section with the idler pulley always

goes on the bottom. Extension sections are mounted between the motor drive

section and the base section. All sections are joined together with tie bars. For

systems up to four modules, two support braces are needed: one attached to the

motor drive and one to the base section. For larger systems, a third support

brace should be mounted near the center of the PTM.

SHR-1704

Figure 3-4. PTM assembled