Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide (July 2000)

6-8 Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide
Compaq Confidential – Need to Know Required
Writer:
Bob Young
Project:
Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide
Comments:
Part Number:
127510-002
File Name:
g-ch6 Diagnostics and Troubleshooting.doc
Last Saved On:
7/12/00 11:32 AM
Table 6-4
Control Error Codes (2xxx)
continued
FSC Message Description
2008 Illegal Move While attempting to perform a MOVE operation, the
source or destination locations were in the wrong
state (FULL or EMPTY).This also occurs if the MOVE
is attempted with an invalid cartridge map.
2009 Door Open A command was received while the door was open.
200A Menu Mode A command was received while the unit was in
Menu mode.
200C Cart Unaccessible An attempt was made to fetch a cartridge from a
drive that is not in the unloaded state. This only
applies when the system is configured for explicit
unloads.
200D Drive In Error An attempt was made to access a drive that is in an
error state.
200E No Magazine The element is not available because the magazine
is not installed.
200F Removal Prevented Medium removal was attempted when in a Prevent
Removal State.
2010 Ctl Firmware Error An invalid configuration was detected. The
configuration jumpers on the main board might not
be set properly.
2011 Ctl Firmware Error A status block was received by the Control Process
operating in a Stand-Alone or Slave configuration.
Since commands are never sent in these modes,
status cannot be received.
2012 Ctl Firmware Error A command was received that was invalid for the
current configuration.
2013 Ctl Firmware Error
2014 Ctl Firmware Error
2015 Ctl Firmware Error
2016 Ctl Firmware Error
continued