Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide (July 2000)

Diagnostics and Troubleshooting 6-7
Compaq Confidential – Need to Know Required
Writer:
Bob Young
Project:
Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide
Comments:
Part Number:
127510-002
File Name:
g-ch6 Diagnostics and Troubleshooting.doc
Last Saved On:
7/12/00 11:32 AM
Table 6-3
SCSI Error Codes (1xxx)
continued
FSC Message Description
1022 SCSI Invalid Semaphore Firmware error.
1023 SCSI Invalid State Firmware error.
1024 SCSI Invalid Ctl Msg A message sent from the control process was not
valid.
1025 Overlapped Ctl Cmds The control process sent a command while one was
in process.
1026 Overlapped Ctl Msgs The control process sent a message while one was
in process.
1027 Control Process . The SCSI control process is busy.
1028 Control Initializing The SCSI control process is initializing.
1030 Invalid SCSI ID The SCSI in NOVRAM is set to >= 8 and the PWB is
not configured for Wide SCSI. Would only occur
during SCSI initialization.
Table 6-4
Control Error Codes (2xxx)
FSC Message Description
2001 Ctl Invalid Command Ctl. Invalid Command.
2002 Undefined Config An unsupported configuration was detected.
2003 Invalid Drive State One of the DLT drives was in an invalid state This is
caused by either attempting to fetch a cartridge from
an empty drive, or stowing to a drive that already
has a cartridge loaded.
2004 Loader Not Ready Currently not displayed.
2005 SCSI Id Not Set An attempt to set the DLT SCSI ID failed.
2006 DLT Comm Open Error An attempt to open a COM port failed.
2007 Door Fault An error occurred while attempting to move the
door.
continued