Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide (July 2000)

5-4 Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide
Compaq Confidential – Need to Know Required
Writer:
Bob Young
Project:
Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide
Comments:
Part Number:
127510-002
File Name:
f-ch5 Regular Maintenance.doc
Last Saved On:
7/12/00 11:11 AM
When you press the
Enter
button, The following screen appears:
Clean: DLT0
Use: Slot0
Cleaning In Progress
When the cleaning operation completes, the Default screen reappears.
Removing the Cleaning Cartridge
NOTE:
If the Base Module is installed in a sufficiently secure area, you can elect not to
use the magazine security lock. In that event, leave the lock in the unlocked position.
1. Look at the Default screen on the control panel to determine whether
any cartridges are loaded into the drives. If so, then unload each using
the Load/Unload menu, as described in Chapter 2, “Operation.”
2. Using the key provided (if necessary), unlock the magazine security
lock on the front panel.
3. Press the
Unlock
/
Open
button on the front panel.
4. Remove the magazine from the Base Module.
5. Remove the cleaning cartridge from the magazine.
6. Mark one of the square boxes on the label of the cleaning cartridge after
each use. If both drives were cleaned, mark two boxes. Note that there is
no mechanism to prevent overuse of the cleaning cartridge. Discard it
after 20 uses or when all the boxes are checked off.
7. Insert any desired data cartridge into the slot vacated by the cleaning
cartridge.
8. Press the
Unlock
/
Open
button on the front panel.
9. Insert the magazine into the Base Module.
10. Using the key provided, lock the magazine security lock on the front
panel (optional).