Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide (July 2000)

4-2 Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide
Compaq Confidential – Need to Know Required
Writer:
Bob Young
Project:
Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide
Comments:
Part Number:
127510-002
File Name:
e-ch4 Configuration.doc
Last Saved On:
7/12/00 11:09 AM
Customizing Your Configuration
To customize your configuration:
1. Turn the Base Module on, and wait until the POST terminates and the
following Default screen appears. Yours might vary depending on the
number of drives in your MiniLibrary system (second line), and the
number and locations of cartridges in the magazine (fourth line).
DLT0 Active
DLT1 Idle
Loader Idle
0 1 2 _ 4 _ 6 7 8 9
2. At the Default screen, press the
Enter
button. The following Main menu
appears:
Load/Unload
Show Status Menu
Maintenance Menu
Configure Menu
3. Press the
button three times to move the to Configure menu, then
press the
Enter
button. The Configure submenu appears. The
at the
end of the fourth line means that there are additional configuration
options that can be reached by scrolling with the
button.
Set Data Format
Set SCSI
Set Library Mode
Set Element Base
4. To select a configuration option, press the
or button on the control
panel until the
on the display is next to the option you want to
change. In this case, choose Set Data Format. Press the
Enter
button to
display the choices for that option. If your Base Module has two drives,
the following submenu appears.
DLT0 Format
DLT1 Format