Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide (July 2000)

ManualsBrandsHP ManualsStorageCompaq SW TL881 DLT Mini-Lib/1 Drive/Table Top/FWD

111

112

113

114

115

116

117

118

119

120

3-32

Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide

Compaq Confidential – Need to Know Required

Writer:

Bob Young

Project:

Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide

Comments:

Part Number:

127510-002

File Name:

d-ch3 Installation.doc

Last Saved On:

7/12/00 11:24 AM

Press the

button three times to move the to Configure menu, then

press the Enter button. The display shows the following Configure

submenu screen. Note that the

at the end of the fourth line means that

there are additional configuration options that can be reached by

scrolling with the

button.

Set Data Format

Set SCSI

Set Element Base

Set Identification

To select a configuration option, press the

or button on the control

panel until the

on the display is next to the option you want to

change. In this case, choose Set SCSI. Press the Enter button to display

the choices for that option. The following submenu appears:

Library Parity:

*Enabled

Library Bus ID:

NOTE:

Look closely at the submenu. Note that the

on the display is next to line 1, and

that line 2 is indented. This tells you that the submenu is a two-tiered menu. The

and

buttons work on two levels in this kind of menu, which is typical of many submenus of

the Configure menu. The first level is as follows: If you press the

button, the moves

to line 3. If you press the

button, the moves back to line 1.

If you press the

Enter

button while the

is next to line 1 (or line 3), the and

buttons operate on the second level. You can tell because the moves next to line 2 (or

line 4), and an

appears at the end of line 4, indicating that there is a list of settings

that can be scrolled using the

and buttons.

The at the end of line 4 means that there are other items that can be displayed by

scrolling, using the

button repeatedly.

Note that the Library SCSI ID is set to 0. Suppose you want to set the

DLT0 bus ID to 3. With the

next to line 1, press the button

repeatedly until the display scrolls as shown:

DLT0 Bus ID:

DLT1 Bus ID: