Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide (July 2000)

Installation
3-31
Compaq Confidential – Need to Know Required
Writer:
Bob Young
Project:
Compaq StorageWorks TL881/TL891 Family MiniLibrary System Reference Guide
Comments:
Part Number:
127510-002
File Name:
d-ch3 Installation.doc
Last Saved On:
7/12/00 11:24 AM
6. Press the
button repeatedly to scroll down to select Alternate Config
screen:
Unit Attn. Report:
*All:
Alternate Config:
*Standalone
7. Press the Enter and then
button to change the line to Slave. Press the
Enter button again and after selection stops flashing. The following
screen appears:
Change Not Effective
Until Reboot
ENTER to Continue
8. Press the Enter button. When the Special Configuration submenu
reappears, turn the power switch off to cycle power.
NOTE:
Expansion unit installation re-maps the cartridge slot numbering system as
follows: The 16-slots of the Expansion Unit become slot numbers 0-15. Slots 0-9 of the
first MiniLibrary Base Module become slots 16-25, etc.
Setting a SCSI ID
1. Turn the system on, and wait until the Power-On Self Test (POST)
completes and the following Default screen appears on the display.
Yours might vary depending on the number of modules in your system,
as shown in the second line.
READY
Modules:0_ _ _ _ _
0 _ _ _ _ _ _ _ _ 9
10
_ _ _ _ _ 15
2. At the Default screen, press the Enter button. The following Main menu
screen appears:
Load/Unload
Show Status Menu
Maintenance Menu
Configure Menu