Compaq StorageWorks TL881/TL891 Family MiniLibrary System Drive Upgrade Procedure (July 2000)

Compaq StorageWorks TL881/TL891 Family MiniLibrary System Drive Upgrade Procedure

Compaq Confidential – Need to Know Required

Writer:

Bob Young

Project:

Compaq StorageWorks TL881/TL891 Family MiniLibrary System Drive Upgrade Procedure

Comments:

Part Number:

127511-002

File Name:

b-ch1 Adding a Second Drive.doc

Last Saved On:

7/12/00 7:16 PM

Replacing

To replace the cover plate on the Base Module:

1. Place the cover plate on the Base Module so that it overhangs one-half

inch at the rear of the module (Figure 3).

2. Slide the cover plate toward the front of the Base Module until the cover

plate touches the front panel.

3. Tighten the captive screw in the center of the cover plate.

4. Connect the power and interface cables at the rear of the module.

5. If the Base Module is a desktop model, replace the skin cover as

described in “Removing and Replacing the Skin Cover (Desktop Models

Only).”

Figure 3. Removing the cover plate

Removing and Replacing the Drive Caddy Assembly

The drive caddy assembly is an enclosure that holds one or two DLT drives

and the interconnecting cables. The assembly includes the SCSI interface

connectors and cables for the Base Module, the power cables for the drives,

and communication cables from the drives to the controller PWB.

SHR-1721