Specifications

MultiBay II eject assembly
Description Spare part number
MultiBay II eject assembly 446434-001
Before removing the MultiBay II eject assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
Battery on page 40).
5. Remove the following components:
a. Hard drive (see
Hard drive on page 44)
b. Bluetooth module (see
Bluetooth module on page 46)
c. MultiBay II device (see
MultiBay II device on page 54)
d. Keyboard (see
Keyboard on page 55)
e. Switch cover (see
Switch cover on page 62)
f. Fan assembly (see
Fan assembly on page 64)
g. Heat sink (see
Heat sink on page 65)
h. Display assembly (see
Display assembly on page 69)
i. Top cover (see
Top cover on page 74)
j. Smart card reader board (see
Smart card reader board on page 77)
k. Microphone (see
Smart card reader board on page 77)
l. Speaker assembly (see
Speaker assembly on page 79)
m. System board (see
System board on page 80)
Remove the MultiBay II eject assembly:
1. Remove the Phillips PM2.0×6.0 screw (1) that secures the MultiBay II eject assembly to the base
enclosure.
Component replacement procedures 85