Installation guide

TARGA 3000 Configuration Cookbook
5.5 IWILL DCA200N
IWILL DCA 200N site
Tested Configuration
- BIOS version 715
- Board version 1.4
+ Two Pentium III Xeon 733 133 Mhz FSB
+ 256 MB RIMM Rambus Memory
+ Matrox G400 16MB single head display adapter)
+ Adaptec 39160 SCSI host adapter BIOS v2.55.0
+Qlogic Dual Channel SCSI QLA12160 Host
Adapter
+IWILL DU3160 Dual Channel SCSI Host Adapter
(Dual Channel external connection requires an
additional internal to external adapter cable.)
+ Integrated Intel 82559 Network Controller
+Integrated AC'97 Audio CODEC
+ 8 Quantum Atlas 10K 9WLS Ultra160m 9 GB
drives
BIOS Settings: Please make sure that MPS 1.1 is
used in advanced BIOS setup menu.
Performance Rating
3 streams YUV uncompressed
Slot Positions
Note: T3K is tested to work with either 64 bit PCI
Slots.
AGP: display adapter (ATI or Matrox)
PCI 32-4: empty
PCI 32-3: empty
PCI 32-2: empty
PCI 32-1: empty
PCI 64-2: AHA-39160
PCI 64-1: Targa 3000
Technical Advisories
1. PCILOCK Boot Option
Specifications and Features
Performance of DCA200 supporting dual 800 MHz
Intel(R) Pentium(TM) III Xeon(TM) processors
Chipset - Intel(R) 840 AGPset, Supports 133MHz /
100MHz FSB
Windbond(R) 83627-HF I/O set
Bus Frequency- "Bye-Bye Jumper(TM)", Iwill Smart
Setting. Supports 133/100MHz FSB
System Memory
4 x RIMM Sockets Support up to 2GB of RDRAM
Modules
Supports 64/128/256/512 MB RDRAM Module
Supports ECC Type and SPD RIMM Module
On Board IDE
Dual Ultra DMA 33/66 IDE Ports
Supports ATAPI IDE CD-ROM, ZIP-100 & LS-120
Expansion Slots
1 x AGP Pro Slot supports AGP Pro 50 and AGP 4X
2 x 64bit/66MHz PCI 2.2 Bus Master Slots
4 x 32bit/33MHz PCI 2.2 Bus Master Slots
BIOS
4MB PLCC FWH(Firmware Hub) with Flash
Board Size
WTX Form Factor - 360mm x 290mm,6 layers