User Guide for iPAQ Connection Point CP-2W

U
SER
G
UIDE
77
Cannot access
Connection
Point CP-2W
configuration
pages through
an Ethernet
adapter.
Network cables
not properly
connected to the
PC or the
Connection Point
CP-2W.
Verify that network cables are properly
connected at both ends and that
Connection Point CP-2W is
plugged in. The Connection Point CP-2W
act LEDs should be flickering on
corresponding cable connections
when PCs are on and connected.
Cannot access
the
Connection
Point CP-2W
configuration
pages through
a wireless
adapter.
SSID and WEP
code on PC and
Connection Point
CP-2W are
different.
From a PC connected through Ethernet,
connect to the web-based configuration
page. Click the Advanced Setup tab.
Verify that SSID and WEP key values on
the web page match wireless
configuration utility values. To access
your wireless adapter utility, refer to
wireless adapter documentation. Change
the value(s) of SSID or WEP on the PC or
Connection Point CP-2W so that the
values match.
Wireless card not
receiving radio
signal.
Check signal strength indicator provided
with your wireless LAN card. See network
card documentation for more information.
If no signal exists or signal very low, try
moving adapter or Connection Point
CP-2W to improve the signal strength.
Symptom Possible Cause Solution