- Hewlett-Packard Plumbing Product User Manual

24
Combi HP thermostatic mixer shower
T00081
Appropriate
fitting
(Riser rail option only)
Complete the outlet pipework ending in a
½" x 15 mm female thread fitting (fig.68).
Note: This fitting is not supplied as variations
in installations needs the selection of the most
suitable fitting.
Screw the supplied male-thread connector into
the female fitting using PTFE tape to make sure
of a watertight joint (fig.69).
Note: The supplied male-thread connector has
a nutted shoulder. If fitting to a flush wall, make
an additional 8 mm allowance for this shoulder
at the finished surface. The connector can be cut
to size if required.
The threaded connector should protrude from
the wall surface between 8 mm and 13 mm.
Make good the wall.
Screw the bulkhead elbow to the threaded
connector using PTFE tape to seal the thread
(fig.70).
Slide the bulkhead over the elbow, offer up
to the wall and mark the two fixing holes for
securing the bulkhead to the wall (fig.71).
Remove the bulkhead then drill and plug the
holes using the plugs supplied.
Refit the bulkhead and secure to the elbow using
two screws (fig.72).
Secure the bulkhead to the wall using the two
fixing screws supplied. Push on the trim disc
making sure the two location lugs locate in the
small holes as shown (fig.73).
FITTING THE BULKHEAD
FITTING THE BULKHEAD
T00082
8mm − 13mm
Finished surface
Fig.68
Fig.69
T00287
T00288
Fig.70 Fig.71
T00289
T00290
Fig.72 Fig.73