HP Designjet T2300 eMFP Series - Using Your Product

Feed and cut the paper
If you go to the front panel and press , then , then Paper > Form feed and cut, the
printer advances the paper and makes a straight cut across the front edge. There are several possible
reasons why you might want to do this.
●
To trim the leading edge of the paper if it is damaged or not straight.
●
To feed and cut the paper when the automatic cutter has been disabled.
●
To cancel the waiting time and print the available pages immediately, if the printer is waiting to
nest more pages.
NOTE: The printheads are serviced after each print, and the paper cannot be cut until the process
completes, so you may notice a delay.
CAUTION: Remove the cut piece from the output tray. If strips or short prints are left in the output tray
the printer could jam.
NOTE: Photo and coated papers require careful handling: they can easily be marked or scratched,
especially if touched soon after printing.
TIP: To move the paper without cutting it, see Move the paper on page 58.
60 Chapter 5 Printer paper handling ENWW