HP Designjet T2300 eMFP Series - Using Your Product

Web Services manual configuration
The Connectivity Wizard (see Set up your Web-connected product on page 28) is normally sufficient
for Web Services configuration, but there are also facilities for manual configuration if you wish to use
them.
Configure the product’s Internet connection
You can configure the product's Internet connection from the Embedded Web Server or from the front
panel.
NOTE: If an administrator password has been set, it will be required to change these settings. Thus,
the administrator can prevent the product from being connected to the Internet, if desired.
●
In the Embedded Web Server: select Setup > Internet connection.
●
Using the front panel: press
, then , then Connectivity > Internet connectivity.
The following settings are available:
●
Enable Internet connection: The default value is Yes.
●
Proxy > Enable proxy: Enable or disable a proxy server.
●
Proxy > Address: Enter the proxy address, empty by default.
●
Proxy > Primary port: Enter the proxy port number, zero by default.
●
Proxy > Restore factory settings: Return to the initial default settings.
If you have trouble with your Internet connection, see
Cannot connect to the Internet on page 200.
Configure firmware updates
You can choose from the Embedded Web Server or from the front panel whether and how to download
firmware updates.
NOTE: If an administrator password has been set, it will be required to change these settings.
●
In the Embedded Web Server: select Setup > Firmware update.
●
Using the front panel: press
, then , then Updates > Firmware update.
The following settings are available:
●
Check: If you select Automatically (the default setting), the product will check automatically
every week (or after the product has been restarted seven times, whichever happens first) whether
new firmware is available. If you select Manually, the product will not check automatically; you
can check manually whenever you like.
●
Download: If you select Automatically (the default setting), the product will automatically
download new firmware whenever it becomes available. If you select Manually, you will be
asked to approve each download.
NOTE: Downloading the firmware does not mean that you have installed it in your product. To
install the new firmware, you must confirm the installation manually.
ENWW
Web Services manual configuration
29